Debug Commands

To enter debug commands, you must first have a Debug Hero unit on the map, then you can type the following (including the -) into the chat window to affect the game.

-debug

Requires that there be a "Debug Hero" unit in play. Turns on debug mode, stops all timers and enables the other commands.

-wipe

Wipes the entire board except the debug hero and the overseer

-set wave X

X is any number >= 0, 0-based, this sets the wave and round. eg. If there are 10 waves, using "-set wave 10" will set the wave to 0 and the round to 1.

-set players X

Sets the number of player slots in use to X (1-4)

-set money

Sets your money to how much you would have at the current wave

-add money

Same as above except adds instead of sets.

-set life X

Sets the life increase per round for the current wave unit. 0.0 being no increase, 0.5 being 50% increase each round, 1.0 being 100% increase each round. This affects all rounds.

-set shields X

Sets the shields increase per round for the current wave unit. 0.0 being no increase, 0.5 being 50% increase each round, 1.0 being 100% increase each round. This affects all rounds.

-set speed X

Sets the speed increase per round for the current wave unit. 0.0 being no increase, 0.5 being 50% increase each round, 1.0 being 100% increase each round. This affects all rounds.

-set count X

Sets the number of units that will spawn for the selected wave. This affects all rounds.

-start

Sends out the currently selected wave then stops