Basically, I have a function that does some work. I want to pass it a couple parameters, but all the work is done within the function. How do I call it from an Action in a Trigger?
This is my first post. I looked through the bug section and didn't find anyone posting anything like this, but it looks like something that other people would notice. I can't put units on the ground that's part of a low cliff.
Steps to reproduce
1) Go to Terrain Layer, use the Cliff Brush and select Lower Cliff
2) Use the brush to make an area of low-lying terrain large enough to place a unit
3) Go back to the Unit Layer and try placing a ground unit in the area(you can't)
4) Go to another part of the map, go back to the Terrain Layer, and this time select Raise Cliff
5) Use the brush to create a plateau
6) Go back to the Unit Layer and try placing a ground unit on the plateau(this time, you can)
0
@nZifnab: Go
Thanks nZifnab, that's exactly what I was looking for!
0
@Magnevv: Go
While I appreciate that the answer might be obvious, I have looked for it. At least give me what Label it's under?
-Sam
0
Basically, I have a function that does some work. I want to pass it a couple parameters, but all the work is done within the function. How do I call it from an Action in a Trigger?
Thanks
0
This is my first post. I looked through the bug section and didn't find anyone posting anything like this, but it looks like something that other people would notice. I can't put units on the ground that's part of a low cliff.
Steps to reproduce 1) Go to Terrain Layer, use the Cliff Brush and select Lower Cliff 2) Use the brush to make an area of low-lying terrain large enough to place a unit 3) Go back to the Unit Layer and try placing a ground unit in the area(you can't) 4) Go to another part of the map, go back to the Terrain Layer, and this time select Raise Cliff 5) Use the brush to create a plateau 6) Go back to the Unit Layer and try placing a ground unit on the plateau(this time, you can)
So, why can't I place units in the valley?
-Xenod