So i have a WoW model and i have a sword attached to its right hand this all works fine. But i notice that the sword is side ways or just rotated a bit from what it should be. Then i noticed there is an attachment point that is usually used for staves to shoot say fireballs or some other spell from.
So what i want to do is attach the top of the sword to this other ref_hardpoint_17 but still have the bottom of the sword attached to the right hand.
I did look and my sword does have a ref_hardpoint_2 located at its tip.
Any help or suggestions would be greatly appreciated
So i have a WoW model and i have a sword attached to its right hand this all works fine. But i notice that the sword is side ways or just rotated a bit from what it should be. Then i noticed there is an attachment point that is usually used for staves to shoot say fireballs or some other spell from.
So what i want to do is attach the top of the sword to this other ref_hardpoint_17 but still have the bottom of the sword attached to the right hand.
I did look and my sword does have a ref_hardpoint_2 located at its tip.
Any help or suggestions would be greatly appreciated
Bump...
You could use SOp site attachment to adjust swords position to your liking. There is a tutorial about it made by ProzaicMuze IIRC