I searched the forums about cliff levels and most of the talk involved the BETA editor. Anyways, I can make one cliff level up and then another level on top of that but no more farther up. Then when I go to make the cliff down, instead of taking the cliff down only one step, it takes it down quite far to the point where I can't create any ramps. If anyone could help, I would appreciate it.
This is not as much as an issue as everyone assumed it would be when the editor was first released. You can make cliffs that look just as good using only the raise / lower brush. As well, you can make the hard cliffs angled and look very good if you lower the terrain height for half of the cliff's width.
Rollback Post to RevisionRollBack
To post a comment, please login or register a new account.
I searched the forums about cliff levels and most of the talk involved the BETA editor. Anyways, I can make one cliff level up and then another level on top of that but no more farther up. Then when I go to make the cliff down, instead of taking the cliff down only one step, it takes it down quite far to the point where I can't create any ramps. If anyone could help, I would appreciate it.
@Hazedsoul: Go
That IS the maximum amount of current cliffs no bugs or anything here
@gankstapony: Go
So there is no way to make a downward cliff in the ground that is accessible by ramp?
You can modify the cliff levels if you want but you cant add any.
Ok, thanks for your help. I guess I can always use the lower terrain and the uniform it to make unlimited levels theoretically.
@Hazedsoul: Go
This is not as much as an issue as everyone assumed it would be when the editor was first released. You can make cliffs that look just as good using only the raise / lower brush. As well, you can make the hard cliffs angled and look very good if you lower the terrain height for half of the cliff's width.